ADC AD-295, WDA-540, AD-26, AD-540 user manual Program Location 05 PL05

H. PROGRAM LOCATION 05 (PL05)

LO Temp

Refer to Section V for instructions on entering program locations.

PL05 Location to be viewed/changed.

	Perm Press			Press “Perm Press” key.
				Display will read “LO°F,” LO Temp
				status for 3-seconds and then the
		LO°F		actual temperature programmed.
				If no changes, press “Perm Press”
				key otherwise press “HI” or “LO”
				keys and then “Perm Press” key.
	(Wait 3-Seconds)
Temperature Decrease			Temperature Increase
LO Temp		120F		HI Temp

Perm Press

Automatically goes into PL06

Program without PL06 Display Mode

Continued on next page

Summary: LO Temp is programmable from a minimum of 100° F to a maximum of 190° F in ten-degree increments or from a minimum of 38° C to a maximum of 88° C in five-degree increments.

For the AD-26 and AD-295any three (3) of the selections (HI/LO/PP) are programmable from a minimum of 100° F to a maximum of 170° F in ten-degree increments or from a minimum of 38° C to a maximum of 77° C in five-degree increments.

For the AD-540 and WDA-540any three (3) of the selections (HI/LO/PP) are programmable from a minimum of 100° F to a maximum of 160° F in ten-degree increments or from a minimum of 38° C to a maximum of 71° C in five-degree increments.

39