ADC AD-540, WDA-540, AD-295, AD-26 user manual Program Location 11 PL11

N. PROGRAM LOCATION 11 (PL11)

Time For Amount To Start

Refer to Section V for instructions on entering program locations.

PL11

Perm Press

tFAS

Location to be viewed/changed.

Press “Perm Press” key.

Upper display will read “tFAS” (Time For Amount To Start) and the lower display will read the actual amount programmed. If no change, press the “PERM PRESS” key, otherwise press the “HI TEMP” key or the “LO

Time Decrease

LO Temp

(Wait 3-Seconds)

4

TEMP” key and then press the “PERM PRESS” key.

Time Increase

HI Temp

("Hold In" to Accelerate)

("Hold In" to Accelerate)

Perm Press

PL12

Proceed to next location

to be changed

To exit program mode, open program switch

Summary: The time for amount to start is programmable from 1 to 99 minutes.

45