Chapter 6. DTE Port Configuration

Setting the IP address to 0.0.0.0 and setting the Mng DLCI to a value not used by the attached frame relay device disables this feature.

IP Address (IP ADDR)

Enter the FSU IP address. Each port capable of carrying IP traffic has its own unique IP address. See the previous section, Guide- lines for Configuring IP Addr, Subnet Mask, and Mng DLCI, for more information.

IP Subnet Mask

Enter the subnet number assigned to the network formed by the FSU and the other FRAD/routers across the frame relay net- work. See the section, Guidelines for Configuring IP Addr, IP Subnet Mask, and Mng DLCI, for more information.

Management DLCI (MNG DLCI)

Enter the management data link connection identifier. The Management DLCI is a special DLCI used between the attached DTE device and the FSU to carry SNMP and telnet packets to/ from the FSU on the DTE port. See the section, Guidelines for Configuring IP Addr, Subnet Mask, and Mng DLCI, for more information.

Protocol Address Table

DTE Port DLCI (PRT DLCI)

Enter the DTE port DLCI into the Protocol Address Table, mapping it to the corresponding Network DLCI. If address translation is not required, set to the value of the corresponding network DLCI element.

Network DLCI (NET DLCI)

Enter the network port DLCI into the Protocol Address Table, mapping it to the corresponding DTE Port DLCI. This element should contain DLCI addresses obtained from the service provider.

Edit Next Entry (NEXT key on front panel)

Edit the next entry in the address table.

61200.130L1-1

FSU User Manual

45

Page 59
Image 59
ADTRAN 1200130L2, 1200130L1 user manual Edit the next entry in the address table