Chapter 6. DTE Port Configuration
No control lead status or break characters are transmitted across the frame relay network.
Physical Layer Options
Interface Type (CONN)
Select the connector type for the DTE interface. The choices are V.35 and
Asynchronous Bit Rate (BIT RATE)
Select the operating speed to match the DTE device connected to the FSU. The selections are 2400 bps, 4800 bps, 9600 bps, 19.2 kbps, and 38.4 kbps.
Data Bits
Select the byte length to match the DTE device connected to the FSU. The choices are 7 and 8.
Parity
Select even, odd, or no parity information. Set to match the DTE device connected to the FSU.
Stop Bits
Select one or two stop bits. Set to match the DTE device con- nected to the FSU.
Hardware Flow Control (HDW FLOW CTRL)
When enabled, the FSU uses CTS to temporarily disable transmit data to the FSU.
Protocol Options
Protocol options are not available when the Transparent Async protocol is selected.
Protocol Address Table
Far End Port Number (FE PORT)
Enter the remote FSU port number that the remote device is connected to.
58 | FSU User Manual |
