Ampro Corporation COM 830 manual Host&Device

Chapter 4BIOS Setup Description

IDE Detect Time Out	0, 5, 10, ... 30, 35	Set this option to stop the BIOS from searching for
(s)		IDE devices within the specified number of seconds.
		Basically, this allows you to fine-tune the settings to
		allow for faster boot times. Adjust this setting until a
		suitable timing can be found that will allow for all
		IDE disk drives that are attached to be detected.
ATA(PI) 80Pin Cable	Host&Device	Select the mechanism for detecting 80Pin ATA(PI)
Detection	Host	cable.
	Device	Note: The use of an 80-conductor ATA cable is
		mandatory for running UDMA66 and faster hard disk
		drives. The standard 40-conductor ATA cable cannot
		handle the higher speeds.

COM 830 Reference Manual 67