AMX MET-ECOM-D manual Ferrite Installation Required, Installing the Metreau Entry Communicator

Mounting and Installation

Ferrite Installation (Required)

The CB-MET-ECOMS comes with a Cat5 Suppression Ferrite that must be clipped around the Ethernet cable, inside the back box (no tools required).

1 2 3

(complete)

FIG. 23 Installing the CAT5 Suppression Ferrite

1.Release the latch to open the plastic enclosure.

2.Insert the Cat5 cable and close the enclosure.

When positioning the Ferrite clip inside the back box, place the bottom of the clip flat against the back inside surface of the back box, to allow sufficient room for the Metreau Entry Communicator unit.

Installing the Metreau Entry Communicator

The Metreau Entry Communicator clips onto the front of the Surface Mount Box via the four mounting tabs (two on each side), and the mounting clip at the bottom center of the box (FIG. 24):

Surface Mount Box

Cables enter through the Conduit Routing Hole in the back panel

bottom security tab

Metreau Entry Communicator

FIG. 24 Installing the Metreau Entry Communicator unit on the Surface Mount Box

Metreau Entry Communicators 27