AMX MET-ECOM-D manual LCD Commands, Get Cam-Flick, Set Disp-Banner, Get Disp-Banner

Programming

Camera Commands (Cont.)

GET CAM-FLICK

Retrieves the flicker mode setting for the camera.

Syntax:

"'GET CAM-FLICK’"

Variables:

•none Example:

SEND_COMMAND MET1,"'GET CAM-FLICK’"

Returns:

CAM-FLICK = 50

The Camera flicker setting is at 50hz mode.

LCD Commands

The LCD located on the face plate (MET-ECOM-D only) supports the following SEND_COMMANDs on port 1.

LCD Commands

SET DISP-BANNER	Syntax:
Sets the banner on the	SEND_COMMAND <DEV>,"'SET DISP-BANNER /mnt/amx/usr/upload/
LCD.	<filename>'"
	Variable:
	• filename = Name of image file on the system to be displayed on the LCD.
	Example:
	SEND_COMMAND MET1,"'SET DISP-BANNER /mnt/amx/usr/upload/
	do_not_disturb.bmp’"
	Image file requirements:
	• BMP image type
	• 128 x 64 pixels
	Refer to the Uploading a Display Image To The Device section on page 46 for
	instructions on uploading image files to the MET-ECOM-D, to be used as
	display images.
	Refer to the Creating Dynamic Images section on page 41 for instructions on
	using TPDesign4 to create Dynamic Images for use with Metreau Entry
	Communicators.
GET DISP-BANNER	Syntax:
Retrieves the banner	SEND_COMMAND <DEV>,"'GET DISP-BANNER <type>’"
displayed on the LCD.	Variable:
	• Type = CURR, LIST
	• CURR -> will give the current bitmap displayed
	• LIST -> will return the list of available bitmaps
	Example:
	SEND_COMMAND MET1,"'GET DISP-BANNER CURR'"
	Returns:
	File: = <path>/<filename>
	filename = Name of file on the system to be displayed on the LCD.

58 Metreau Entry Communicators