APC AP9208, AP9608 manual Paging Setup Events, Event Description

will page the first pager but not the second, and that the first pager will show a “5” after the Site ID when it receives the page.

Note: The default code numbers defined by the Paging Setup menu varies widely according to the type of UPS. Measure-UPS, zone, and probe alarms apply only if those devices are present, even though they appear on the menu.

	PAGING SETUP (EVENTS)
Event		Description
UPS		UPS is operating on battery power because of utility
		line problems. The Message Delay setting (see earlier
ON-BATTERY
		Paging Setup menu table) has been exceeded.
AC-FAIL/		Utility power has failed, and the UPS battery is nearly
LOW BATTERY		exhausted.
UPS		UPS has been shut down by command or low-battery
SHUT DOWN		condition.
UPS ON-LINE		UPS has returned to online operation (after an on-
		battery, low-battery, or shutdown condition).
REPLACE BATTERY		UPS has issued a Replace Battery alarm.
UPS FAULT		UPS has detected an internal fault.
MEASURE-UPS		Measure-UPS environment monitor associated with the
ALARM		connected UPS has issued an alarm.
MEASURE-UPS ALL		All alarms from Measure-UPS have been cleared.
CLEAR
		Zone monitor (1–4) has detected a condition that
ZONE [n]		exceeds preset zone monitor limits. For use with
		Measure-UPS only.
ZONES CLEAR		Conditions triggering earlier Zone alarms have been
		cleared.
		Probe monitor (1–2) has detected a temperature or
PROBE [n]		humidity condition that exceeds preset probe limits.
		For use with Measure-UPS only.
PROBES CLEAR		Conditions triggering earlier Probe alarms have been
		cleared.

35