43
Symmetra Power Array
For installation of multiple SmartSlot devices in the Symmetra Power
Array, refer to the numbering in the figure that follows. Note that the
PowerNet SNMP Adapter is installed in slot #4, Call-UPS II in #3, no
device in #2, and Measure-UPS in #1.
If you are using an external SmartSlot housing (Expansion Chassis or
Triple Chassis) in conjunction with a Symmetra Power Array, install the
devices with higher priority in the external slot(s). Refer to the earlier
Triple Chassis section, if applicable.
SmartSlotSmartSlot
Probes
1 2
Sensor Zones
AP9612 Measure-UPS™
1 2 3 4
GND
Management Port
Status
AP9608 Call-UPS Remote Mgt DeviceAP9608 Call-UPS Remote Mgt Device
SmartSlotSmartSlot
SmartSlotSmartSlot
Reset
Status
Link - RX/TX
AP9605 PowerNet™ SNMP Adapter™
Computer
Battery Communications
Comm.1 Comm.2
Interface
Display
Comm.
4 123
Daisy Chains
If you have increased your SmartSlot capacity by daisy-chaining
Expansion Chassis or Triple Chassis, install the PowerNet SNMP
Adapter and Call-UPS II in the highest-numbered and second-highest-
numbered slots, respectively, of the chassis installed farthest from the
UPS.
Smart-UPS and Matrix-UPS
If your APC UPS has only one SmartSlot, install the low-priority devices
in the UPS SmartSlot and use an external SmartSlot housing (Expansion
Chassis or Triple Chassis) for the device(s) with higher priority. Refer to
the earlier Triple Chassis section, if applicable.