APC AP9208, AP9608 manual Paging Setup, Setting

-----------------------		PAGING SETUP		------------------------
1-	Paging: ON
2- Dial String 1: DT9,5551212@
3- Dial String 2: DT9,5551212@
4-	Repeat 1:	1	8-	Site ID:	12345678
5-	Repeat 2:	1	9- Space Char:		*

6- Page Interval:		1 min				10- Dial Speed: Slow
7- Message Delay:		15 sec				11- End String:
--- EVENT ------ NUM:			1	2	CODE -- EVENT--NUM:		1	2	CODE
12- UPS ON-BATTERY			Y	N	0	20- ZONE 1	Y	N	8
13-	ON & LOW BATTER		Y	N	1	21- ZONE 2	Y	N	9
14-	UPS SHUT DOWN		Y	N	2	22- ZONE 3	Y	N 10
15- UPS ON-LINE			Y	N	3	23- ZONE 4	Y	N 11
16-	REPLACE BATTERY		Y	N	4	24- ZONES CLEARY		N 12
17-	UPS FAULT		Y	N	5	25- PROBE 1	Y	N 13
18-	LOST COM W/ UPS		Y	N	6	26- PROBE 2	Y	N 14
19-	BYPASS		Y	N	7	27- PROBES CLEARY N 15

-------------------------------------------------------------

?- Help <ENTER> Display menu

<ESC> Return to Previous menu

>

		PAGING SETUP
Setting	Default	Description
Paging	OFF	To enable paging, enter 1 when prompted. Enter 0 to
		disable.
		Dial string for the pager (the first pager if two are
		used). Use standard modem commands such as:
Dial	D T9,	DP — dial in pulse mode; DT — dial in tone mode
String 1	5551212@	W — wait for second dial tone; , (Comma) — pause
		(typically for 2 seconds); @ — wait for a quiet
		answer (5 seconds of silence)
Dail	D T9,	Dial string for a second pager number.
String 2	5551212@
		Number of times, from 0–4, that the page for the first
		pager number is repeated. Call-UPS II cycles through
		Repeat 1, Repeat 2, and Page Interval for each report-
Repeat 1	1	able event. Events are buffered and p rioritized during
		paging to keep the operator updated with the best
		information. Note: paging is also controlled on an
		event basis (see later chart). Set Repeat to 0 to dis-
		able a pager without having to disable all the events.
Repeat 2	1	Same as Repeat 1, for pager associated with Dial
		String 2.

33