With Symmetra Power Array
Type 1, then ENTER at the Main menu to display the Status and Diagnos- tics screen of the connected Symmetra Power Array.
SYMMETRA STATUS | ||||||
IM Status: On & Ok |
|
|
| Last Xfer: None |
| |
RIM Status: Off & Failed |
| Last Self test: OK |
| |||
INPUT/OUTPUT |
| |||||
Input: | 246.0 V at 60.04 Hz | Load Assuming No Redundancy: 000 % | ||||
Output: | 000.0 V at 60.04 Hz | Allowing for n+1 Redundancy: 000 % | ||||
Load Current: | 00.0 A |
|
|
| Capacity: | 16.0 kVA |
|
|
|
|
| Alarm if Over: 06.0 kVA | |
POWER MODULES |
| |||||
Installed: | 05 |
|
|
| Fault Tolerance: | n+0 |
Bad: | 00 |
|
|
| Alarm if Under: | n+2 |
BATTERIES |
| |||||
Installed: | 004 | Voltage: | 137.1 VDC | Runtime: 0244 min. | ||
Bad: | 000 | Capacity: | 98.0 % | Alarm if Under: 015 min. | ||
System
1- Main Frame Information
2- External Battery Frame Information for frame(s): 1, 2, 3, 6, 7 <ENTER>=Refresh, <ESC>=Main menu>, ?=Help>
The following table describes the items on the UPS Status and Diagnos- tics screen when
UPS STATUS AND DIAGNOSTICS (Symmetra Power Array)
Item | Description | |
|
| |
IM Status | Status of the Intelligence Module. | |
|
| |
RIM Status | Status of the Redundant Intelligence Module. | |
|
| |
| Reason for the last UPS transfer to battery. Possible | |
Last Xfer | results are: Test, Low Voltage, HiVoltage, Rate of | |
| Change, and Notch/Spike. | |
|
| |
Last Self Test | Results of the last Self Test. Possible results are listed | |
in earlier Self Test Table in this section. | ||
| ||
|
| |
Input | Utility line input, in volts AC RMS and in hertz. | |
|
| |
Output | UPS output to the load, in volts AC RMS and in hertz. | |
|
| |
Load Current | Amount of current being drawn by the load, in amps. | |
|
|
15
