Administering Options for the 1600 Series IP Telephones
Issue 5 April 2010 71
PHNDPLENGTH 5 Internal extension telephone number length. Specifies
the number of digits associated with internal extension
numbers by the algorithm that dials calls from the
incoming Call Log or from Web pages. Range: 1 or 2
digits, from “3” to “10.”
PHNIC 011 Telephone international access code. The maximum
number of digits, if any, dialed to access public network
international trunks by the algorithm that dials calls
from the incoming Call Log or from Web pages. Range:
0-4 digits.
PHNLD 1 Telephone long distance access code. The digit, if any,
dialed to access public network long distance trunks by
the algorithm that dials calls from the incoming Call Log
or from Web pages. Range: 1 digit or " " (Null).
PHNLDLENGTH 10 Length of national telephone number. The number of
digits in the longest possible national telephone
number by the algorithm that dials calls from the
incoming Call Log or from Web pages. Range: 1 or 2
digits, from “3” to “10.” Range: 1 or 2 ASCII numeric
characters, from “5” to “15.”
PHNOL 9 Outside line access code. The character(s) dialed,
including # and *, if any, to access public network local
trunks by the algorithm that dials calls from the
incoming Call Log or from Web pages. Range: 0-2
dialable characters, including " " (Null).
PHY1STAT 1Ethernet line interface setting (1=auto-negotiate,
2=10Mbps half-duplex, 3=10Mbps full-duplex,
4=100Mbps half-duplex, 5=100Mbps full-duplex, and
6=1000Mbps full-duplex if supported by the hardware).
PHY2PRIO 0 Layer 2 priority value for frames received on or
forwarded to the secondary Ethernet interface. Set this
parameter only when VLAN separation is "1"
(enabled). Values are from 0-7 and correspond to the
drop-down menu selection.
PHY2STAT 1Secondary Ethernet interface setting
(0=Secondary Ethernet interface off/disabled,
1=auto-negotiate, 2=10Mbps half-duplex, 3=10Mbps
full-duplex, 4=100Mbps half-duplex, 5=100Mbps
full-duplex), and 6=1000Mbps full-duplex if supported
by the hardware).
PHY2VLAN 0 VLAN identifier used by frames received on or
forwarded to the secondary Ethernet interface. Set this
parameter only when VLAN separation is "1"
(enabled). Value is 1-4 ASCII numeric digits from “0” to
“4094.” Null is not a valid value, nor can the value
contain spaces. If this value is set by LLDP using the
Port VLAN ID TLV value, it will not change regardless
of settings from other sources. For more information,
see Parameter Data Precedence.
Table8: 1600 Series IP Telephone Customizable System Parameters (continued)
Parameter Name Default Value Description and Value Range
4 of 6