Interface Control

Status is 100Mbps HDX when PHY2STAT = 4

Status is 100Mbps FDX when PHY2STAT = 5

5.To change the PHY2 value, press *.

Depending on the current value, the next sequential valid PHY2 value is selected and displayed as the status. For example, if the current value is 10Mbps HDX (2), pressing * changes the value to 3 (10Mbps FDX).

The following text displays left-justified at the top of the display:

Save new value?

*=no #=yes

6.Press the * button to terminate the procedure, or the # button to save the new values. If you press the # button, the following text displays.

New value being saved

The new values are saved and a restart occurs automatically. The user interface is restored to its previous state.

The View Administrative Option

If you are using static addressing and encounter problems, use the following procedure to verify the current values of system parameters and file versions.

Note:

Unless otherwise prevented using administration, the user can view but not change most of the parameters associated with Local Administrative Procedures. For more information about this option, see the applicable user guide(s).

Note:

If the View Network Information option is not available due to being disabled by administration, use the ADDR option to view IP addresses. See Static Addressing Installation on page 94. The IP addresses might have been entered incorrectly. Verify whether you were provided with correct IP addresses.

Issue 5 April 2010 91

Page 91
Image 91
Avaya 1600 Series, 16-601443 manual View Administrative Option