Avocent 590-686-501D Commands Dialog Box Functions, To list target devices alphabetically by name

Chapter 3: Local Port Operation 35

4.Repeat steps 1-3 for each target device in the system.

5.Click OK in the Names dialog box to save your changes. -or-

Click X or press Escape to exit the dialog box without saving changes.

NOTE: If an IQ module has not been assigned a name, the EID is used as the default name.

To list target devices alphabetically by name:

Press Alt+N or click Name in the Main dialog box.

Commands Dialog Box Functions

From the OSCAR interface Commands dialog box, you can manage your DSR switching system and user connections, enable the Scan and Broadcast modes and update your firmware.

Table 3.7: Commands to Manage Routine Tasks for Your Target Devices

Features	Purpose
Broadcast	Begin broadcasting to your target devices. Configure a target device list for broadcasting
Enable	under the Setup dialog box.
Scan Enable	Begin scanning your target devices. Set up a target device list for scanning in the Setup
	dialog box.
User Status	View and disconnect users.
Display Versions	View version information for the DSR switch as well as view and upgrade firmware for
	individual IQ modules.
Reset PS/2	Re-establish operation of PS/2 keyboard and mouse.
Network Ping	Ping a specific IP address.

To access the OSCAR interface Commands dialog box:

1.If the OSCAR interface is not open, press Print Screen to open the Main dialog box.

2.Click Commands to open the Commands dialog box shown in Figure 3.18.