INSTALLATION MANUAL

Remote Controller Wireless Kit

RBC-AX22CE

– 162

Accessory parts

No.

Accessory

Q’ty

No.

Accessory

Q’ty

1

Sensor unit

1

4

Battery

2

2

Remote controller

1

5

Owner’s Manual

1

3

Remote controller holder

1

6

Truss tapping screw, 4 ×16

2

Installation of sensor unit

1. Open the suction grille, remove a screw, move the side panel toward you (direction of arrow), and then remove the side panel. (Fig. A)

2. Lap the end of flat head screw driver with vinyl tape, and forcedly insert it into the groove at the side under circle mark on the cover. (Be careful not to damage the panel.) (Fig. B)

3. Pass the lead wire through the panel, and install the sensor unit to the panel hole. (Projection of the sensor unit is fixed by the panel hole.)

4. Fix the lead wire of the sensor to the cord clamp which fixes the cables of the louver motor. (Fig. C)

5. Install the side panels.

6. Put the lead wire from the sensor unit along cables of the louver motor and others, and then fix it with the cord clamp. (Fig. D)

* Draw in it using a hole at the upper side of the electric box.

Flat head screw driver

Fig. A

Fig. B

(Lap it with vinyl tape.)

Thank you very much for purchasing TOSHIBA Remote Controller for Air Conditioner.

Please read this owner's manual carefully before using your Remote Controller for Air Conditioner.

Be sure to obtain the “Owner’s manual” and “Installation manual” from constructor (or dealer).

Request to constructor or dealer

Please clearly explain the contents of the Owner’s manual and hand over it.

Panel

Side panel

Suction grille

Fig. C

Cord clamp

Sensor

Vinyl tape

Cover

Insert it into groove at the side under circle mark on the cover.

Cord clamp

Fig. D

Terminal block for remote controller cabling

RBC-

[NOTE 1]

Avoid to twist cables of the sensor with the power cables, otherwise a malfunction is caused.

*For cabling and test run, refer to “Cabling of sensor unit” of these sheets and “Test run” of the Installation Manual attached to the indoor unit.

AX22CE

Page 86
Image 86
Balcar R410A service manual 162, Installation of sensor unit, Accessory