Balcar R410A service manual Wiring diagram, 135

RAV-SM561, 801CT-E RAV-SM1101, 1401CT-E

Cabling

1.Remove a screw and then remove cover of the electric parts box.

2.Strip wire ends (10 mm).

3.Match wire colors with terminal numbers on indoor and outdoor units’ terminal blocks and firmly screw wires to the corresponding terminals.

4.Connect the ground wires to the corresponding terminals.

5.Fix the cable with cord clamp.

6.Fix cover of the parts box and the terminal block surely with the fixing screws.

Remote Controller Cabling

•Strip off approx. 14mm the cable to be connected.

•Non polarity, 2 core cable is used for cabling of the remote controller.

•Twist cable of the remote controller to be connected with cable of the remote controller unit (or sensor), and press-fit them with a wire joint.

Wire joints (White: 2 pieces) are included in the attachments to the remote controller (sold separately) or the wireless remote controller kit (sold separately).

Make a loop on the cable for margin of the length so that the electric parts box can be taken out during servicing.

10
1	2	3
		10
120
		50	60	70
Earth line		Connecting cable

C

B

A

Cabling diagram

Terminal block
for remote controller	Approx. 200mm			W : White
cabling of indoor unit				B : Black
A		W
				Remote
B		B		controller unit
				or sensor part
Remote controller cable	Connecting		Remote controller unit or
(Local procure)	part		cable from sensor part

Remote controller cabling

Cable from remote

controller unit Wire joint

Wiring diagram

Remote controller

Remote controller

cable

A B

Indoor side

1 2 3

Indoor/Outdoor connecting cable

1 2 3

Outdoor side

L N

(Single phase 220-240V)

•For details of cabling/installation of the remote controller, refer to the Installation Manual attached to in the remote controller.

– 135 –