Black & Decker DV1210ECN, DV9610ECN manual Additional safety instructions

Additional safety instructions

After use

uUnplug the charger before cleaning the charger or charg- ing base.

uWhen not in use, the appliance should be stored in a dry place.

uChildren should not have access to stored appliances.

Residual risks.

Additional residual risks may arise when using the tool which may not be included in the enclosed safety warnings. These risks can arise from misuse, prolonged use etc.

Even with the application of the relevant safety regulations and the implementation of safety devices, certain residual risks can not be avoided. These include:

uInjuries caused by touching any rotating/moving parts.

uInjuries caused when changing any parts, blades or ac- cessories.

uInjuries caused by prolonged use of a tool. When using any tool for prolonged periods ensure you take regular breaks.

uImpairment of hearing.

uHealth hazards caused by breathing dust developed when using your tool (example:- working with wood, especially oak, beech and MDF.)

Batteries and chargers

Batteries

uNever attempt to open for any reason.

uDo not expose the battery to water.

uDo not expose the battery to heat.

uDo not store in locations where the temperature may exceed 40°C.

uCharge only at ambient temperatures between 10°C and 40°C.

uCharge only using the charger provided with the appli- ance/tool. Using the wrong charger could result in an electric shock or overheating of the battery.

uWhen disposing of batteries, follow the instructions given in the section "Protecting the environment".

uDo not damage/deform the battery pack either by puncture or impact, as this may create a risk of injury and fire.

uDo not charge damaged batteries.

uUnder extreme conditions, battery leakage may occur. When you notice liquid on the batteries carefully wipe the liquid off using a cloth. Avoid skin contact.

uIn case of skin or eye contact, follow the instructions below.

(Original instructions) ENGLISH

Warning! The battery fluid may cause personal injury or damage to property. In case of skin contact, immediately rinse with water. If redness, pain or irritation occurs seek medical attention. In case of eye contact, rinse immediately with clean water and seek medical attention.

Chargers

Your charger has been designed for a specific voltage. Always check that the mains voltage corresponds to the voltage on the rating plate.

Warning! Never attempt to replace the charger unit with a regular mains plug.

uUse your Black & Decker charger only to charge the bat- tery in the appliance/tool with which it was supplied. Other batteries could burst, causing personal injury and damage.

uNever attempt to charge nonrechargeable batteries.

uIf the supply cord is damaged, it must be replaced by the manufacturer or an authorised Black & Decker Service Centre in order to avoid a hazard.

uDo not expose the charger to water.

uDo not open the charger.

uDo not probe the charger.

uThe appliance/tool/battery must be placed in a well venti- lated area when charging.

Electrical safety

Your charger has been designed for a specific voltage. Always check that the mains voltage corresponds to the voltage on the rating plate. Never attempt to replace the charger unit with a regular mains plug.

Symbols on the charger

Read all of this manual carefully before using the # appliance.

This tool is double insulated; therefore no earth wire is required. Always check that the power supply

wcorresponds to the voltage on the rating plate. Short circuit proof safety isolating transformer. The mains supply is electrically separated from the

x transformer output.

The charger automatically shuts off if the ambient temperature becomes too high. As a consequence the charger will be inoperable. The charging base must be disconnected from the mains supply and

$taken to an authorised service centre for repair. The charging base is intended for indoor use only.

5