Bosch Appliances manual D9412G/D7412G Program Entry Guide 6.0 RADXAUX1

D9412G/D7412G Program Entry Guide 6.0 RADXAUX1

EN 119

Both the U.S.Robotics V.92 56 K Modem (model # 5686, includes V.92 and V.90 56 K standard technology) and the Best Data Smart One V.92/V.44 56 K External Data/Fax Modem (model # 56SX-92) are recommended for use as external modems (connected to the control panel) based on compatibility testing by Bosch Security Systems. Other modules were either not tested or found compatible.

The following seven prompts help configure the requirements necessary to connect an external modem to a D9412G/D7412G Control Panel using a D9133DC. This configuration allows you to communicate with RPS at 9600 baud because communication is being routed through the SDI bus.

Use a separate phone line if an external modem is being connected to the control panel by a D9133DC Direct Connect Programming Module. If it is not possible to obtain a different phone line than the control panel is using, make sure the control panel is still wired in front of any premises phone and the external modem devices so that full line seizure is maintained. Also, make sure the following items are programmed in Section 2.7 RAM Parameters:

•Answer Armed = Blank or 0

•Answer Disarmed = Blank or 0

•RAM Line Monitor = No

•RAM Call Back = No

•RAM Phone number = Blank

When using an external modem, it must be initialized using the following HyperTerminal procedure on your computer. The HyperTerminal procedures can vary depending upon the operating system used.

3.In Windows®, open the HyperTerminal

application within

Programs→ Accessories→ Communications.

4.Connect the modem to an available COM port.

5.Once connected, select the appropriate COM port within HyperTerminal. See Figure 7.

For Best Data Smart One V.92:

Type [A][T][S][3][7][=][9][Enter] For US Robotics:

Type [A][T][&][N][6][Enter].

This sets the baud rate of the modem to 9600. For modems other than US Robotics or Best Data Smart One V.92, consult your individual modem’s instructions for the correct text string.

Type [A][T][E][0][Enter]. This eliminates echo, making all user input from this point forward invisible on screen.

Type [A][T][&][W][0][Enter] to write the configuration to modem memory. The modem profile is saved to a file upon disconnection or power loss.

The external modem is connected to the D9133DC Direct Connect Programming Module, which in turn, is connected to the SDI bus using SDI Address 88 (see Figure 8). A standard serial cable is required to connect the D9133DC to the external modem.

If you are going to use an external modem for RPS communications, enhanced communications, and RPS functions using a D9133TTL-E are disabled.

Bosch Security Systems 1/04 47775E