![](/images/new-backgrounds/1012804/1280495x1.webp)
D9412G/D7412G Program Entry Guide 2.0 9000MAIN
EN 48
CC# A1[through A8] in Scope
Default: | See preceding important note |
Selection: | Yes or No |
|
|
Yes | Include this area in the scope of this |
| command center. |
|
|
No | Do not include this area in the scope of |
| this command center. |
|
|
Determines whether any of the eight areas (Area 1 to Area 8) and Doors (Door 1 to Door 8) are included in the scope of this command center for viewing status, arming or disarming, and controlling doors from the command center.
CC# Entr Key Rly
Default: | Blank |
Selection: | 1 to 128, A, B, C, and Blank |
|
|
Blank | The [ENTER] key is not used to cycle |
| a relay. |
|
|
1 to 128, | Assign the relay number that activates |
A, B, C | when [ENTER] is pressed at this |
| command center after the user enters a |
| valid passcode. |
|
|
Enter Key Relay: Program the relay number that momentarily activates for 10 seconds when a user enters a valid passcode and presses the [ENTER] key on the command center. Two events are generated when this function is used: RELAY ###
SET with User ID, and RELAY ### RESET without User ID.
When programmed to activate a relay, the [ENTER] key cannot be used for any other function.
Relays used for this function must not be shared with any other point, sensor reset, control panel, or bell functions. This can cause erroneous relay operation.
1. Entering a valid code and pressing [ENTER] silences a bell if one is ringing.
2.Use this function for a
3.This action is logged as two events, Relay Set and Relay Reset.
CC# Entr Cycl Dr
Default: No
Selection: Yes or No
Yes | The [ENTER] key is used to cycle the |
| door programmed for CC Assign |
| Door. |
|
|
No | The [ENTER] key is not used to cycle |
| the door. |
|
|
Enter Key Cycle Door: Program this prompt as Yes to initiate the door cycle sequence (this includes shunting the point assigned to the door) for the door number programmed in CC Assign Door when a user enters a valid passcode and presses [ENTER]. ACCESS GRANTED prints on the local printer and at the central station receiver, if programmed.
The service passcode cannot be used for the CC# Entr Cycl Dr application.
When programmed to activate a relay, the [ENTER] key cannot be used for any other function.
Relays used for this function must not be shared with any other point, sensor reset, control panel or bell functions. This can cause erroneous relay operation.
| 1. The door does not cycle if Entr Key |
0101 | Rly is programmed. |
2.9210 NOT READY appears at this command center when you press [ENTER] if the D9210B is not programmed with a D# Entry Area (in the RADAXS handler) or if CC Assign Door does not have a door number assigned.
Bosch Security Systems 1/04 47775E