Bosch Appliances D9412G, D7412G # Close Early Begin, Programming to Link Two Days over Midnight

D9412G/D7412G Program Entry Guide 5.0 RADXSKED

EN 98

Table 32: Programming for Two Same Day Opening Windows (see Figure 4)

W#

1

2

Day of Week

S M T W T F S

S M T W T F S

Open Close

Early			Early
Begin	Start	Stop	Begin	Start	Stop
06: 00	07 : 00	08: 00
13 : 00	14 : 00	15 : 00

eXcept

On

Holiday

Yes / No

Yes / No

Holiday

Index

1 2 3 4

1 2 3 4

Area(s)

1 2 3 4 5 6 7 8

1 2 3 4 5 6 7 8

Do not program a single window to cross the midnight boundary. The window stop time must be later than the window start time. To program a window that effectively crosses the midnight boundary, you must program two windows.

For example, to program windows for an area that opens between 11:30 PM and 12:30 AM, five days a week, use two windows as shown in Table 33.

Table 33: Programming to Link Two Days over Midnight

			Open			Close		eXcept
		Early			Early			On			Holiday
W#	Day of Week	Begin	Start	Stop	Begin	Start	Stop	Holiday			Index						Area(s)
1	S M T W T F S	22 : 00	23 : 30	23 : 59				Yes	No	1	2	3	4	1	2	3	4	5	6	7	8
2	S M T W T F S	00 : 00	00 : 00	00 : 30				Yes	No	1	2	3	4	1	2	3	4	5	6	7	8

W# Close Early Begin

Default: 00: 00

Selection: HH:MM (hours and minutes)

00:00 to 23:59

Close Early Begin: This program item is one of three required to create a Closing Window. To finish programming a Closing Window, Close Window Start and Close Window Stop must be programmed.

Use Close Early Begin to set the time that you want the control panel to look for a Closing Window. When Opening and Closing Reports are enabled, arming the area between midnight and the Close Early Begin time generates a Closing Report. In addition:

•If Disable O/C in Window is Yes: Arming the area between the Close Early Begin time and the Close Window Start time generates a Closing Early Event (if the Close Early Begin time is the same as the Close Window Start time, the Closing Early Event is not sent).

Arming the area between the Close Window Start and Close Window Stop time creates a local event in the Panel log but does not send the Closing Report to the central station.

Arming the area after the Close Window Stop and the next window’s Close Early Begin time (or midnight, whichever comes sooner) generates a Closing Late Event.

•If Disable O/C in Window is No: Disarming the area generates a Closing Report without the early or late modifier, regardless of when the area is armed.

When you are programming multiple windows to activate on a single day, program the windows in chronological order. Be careful not to program a window’s Close Early Begin time for a time that is between any other window’s Close Window Start and Close Window Stop time.

Disabled windows have a blank begin time. If the entry for this prompt is blank, but times are programmed for Close Window Start and Close Window Stop, the window is disabled.

To disable the window, both the hours and minutes spaces must be blank.

00:00 is midnight, 23:59 is 11:59 PM. Make entries using a 24-hour clock (for example, 7:00 AM is entered as 07:00, 2:45 PM is entered as 14:45).

Bosch Security Systems 1/04 47775E