Bosch Appliances D9412G, D7412G Phone Supv Time, Alarm On Fail, Buzz on Fail, Two Phone Lines

D9412G/D7412G Program Entry Guide 2.0 9000MAIN

EN 14

Phone Supv Time

Default: Blank

Selection: Blank or 10 to 240

Blank	No phone line supervision.
10 to 240	Enter the number of seconds (in 10
	second increments) you wish to
	supervise the phone line. After a faulted
	phone line restores, it takes the same
	amount of time to initiate restoral
	responses.

Phone line trouble responses: Command centers display SERVC PH LINE # to indicate which phone line failed. The command center initiates a trouble tone if Buzz on Fail is Yes and CC Trouble Tone is Yes.

With dual phone lines (using the D928 Module), the restored phone line handles all messages regardless of the phone line’s number.

Phone, Trouble, and Restoral Events report when they occur. They report also when a Diagnostic Report is initiated from a command center or by a Sked.

Alarm On Fail

Default: No

Selection: Yes or No

Yes	Generate alarm responses when a
	phone line fails.
No	Phone failures report as trouble
	responses for Area 1 and/or the
	account number for Area 1.

0101	Phone Supv Time must be programmed to
	use this feature.

Phone Failure Alarm Responses: The Alarm Bell relay for Area 1 activates. All Phone Event messages report as Area 1 and/or the account number for Area 1.

Buzz on Fail

Default:	No
Selection:	Yes or No
Yes	Generate panel-wide trouble tones and
	display PHONE FAIL # at command
	centers when a Phone Fail Event
	occurs.
No	Does not generate trouble tones at
	command centers when a Phone Fail
	Event occurs. PHONE FAIL # still
	displays.

0101	Phone Supv Time must be programmed to
	use this feature.

De-selecting individual command centers for panel-wide trouble tones: Panel-wide trouble tones for programming

CCcan turn off individual command centers (based on their CC # 1 through 8)

# Trouble Tone in Command Center Parameters as No.

Two Phone Lines

Default: No

Selection: Yes or No

Yes	The D928 Dual Phone Line Module is
	installed. The LEDs on the D928 light
	to indicate primary or secondary line
	trouble and COMM FAIL.
No	No D928 Dual Phone Line Module.

Use this program item when a D928 Dual Phone Line Module is connected to the control panel. Both lines must operate the same; either ground start or loop start.

0101	IMPORTANT! Program Phone Supv Time
	when using two phone lines.

NFPA standards prohibit the use of ground start phone lines in systems monitoring Fire points.

Bosch Security Systems 1/04 47775E