Bosch Appliances D7412G, D9412G ## Entry Delay, ## Ent Tone Off, ## Silent Bell, ## Ring Til Rst

D9412G/D7412G Program Entry Guide 4.0 RADXPNTS

EN 83

P## Entry Delay

Default: See Program Record Sheet

Selection: 5 seconds to 600 seconds

Use this option to enter the amount of entry delay time that a user has after faulting a Controlled point (P## Type 1, 2, 3) with a delayed response (D) (P## Pt Response) of 4, 5, 6, 7, or 8. DISARM NOW displays for the duration of the time programmed when the point is faulted in the delay condition.

Beginning with firmware revision 6.30 and higher, the D1255 alternates between DISARM NOW and the point text of the point that caused the area to go into entry delay.

If this time expires before disarming, or if the point is faulted to an instant response (I), an alarm occurs.

	Make entries in 5 second increments. The
0101	programmer does not allow off-increment
	entries.

If another Perimeter or Interior Follower Delay point trips while the area is already in entry delay, the control panel adjusts the delay time to the Delay point with the least amount of delay time.

Use P## Type 3 Interior Follower to program points that do not go into instant alarm the user must fault in order to get to the command center and disarm during the entry or exit delay period.

P## Ent Tone Off

Default: No

Selection: Yes or No

Yes	Disable entry delay tone when this
	point is faulted to the delay response.
No	A tone sounds at command centers
	when this point initiates entry delay.

This option enables/disables the entry delay warning tone for this point.

Do not set points to No if they are actually used to notify the user to disarm the system. The possibility of false alarms increases if the entry delay warning is not used.

	Entry Tone can also be turned off when
0101	programming your CC Entry Tone, in
	Section 2.10 Command Center, which
	allows you to manage the tone by
	command center.

You may want to disable the entry tone in high security applications where you do not want to annunciate entry delay.

P## Silent Bell

Default:	No
Selection:	Yes or No
Yes	Activate the Silent Alarm relay when
	this point goes into alarm. Command
	centers do not sound the alarm tone
	for Non-fire points.
No	Activate either the Fire Bell relay or
	Alarm Bell relay and sound the alarm
	tone at command centers when this
	point goes into alarm. If this is a Fire
	point, it activates the Fire Bell relay
	programmed in Relay Parameters.
	Otherwise, it activates the Alarm Bell
	relay. The amount of time and pattern
	of the relay activation is programmed
	by area in Bell Parameters.

If you want this point to eventually ring the bell because the message failed to reach the central station receiver, program P## Audible After 2 Failures as Yes.

P## Ring Til Rst

Default: No

Selection: Yes or No

Yes	The relay programmed to provide fire
	alarm output for this point cannot be
	de-activated until the point restores to
	normal.
No	The relay programmed to provide fire
	alarm output for this point can be de-
	activated before the point restores to
	normal.

Use this option to determine if the bell continues to ring until the Fire Bell time expires. The point returns to a normal condition when the user acknowledges the alarm to silence the bell.

Bosch Security Systems 1/04 47775E