Bosch Appliances D7412G, D9412G manual Programming the Pager Phone Number, RG# Primary Pager

D9412G/D7412G Program Entry Guide 2.0 9000MAIN

EN 25

RG# Primary Pager

Default: No

Selection: Yes or No

Determines if this route group sends events to a numeric pager. To send events to a numeric pager, a phone number must also be programmed in the route group’s primary destination.

	If programming the control panel to dial a
0101	numeric pager, choose its route group
	carefully. If there are any events to transmit
	to a central station, be sure to place those
	events in a lower numbered route group
	class than the events that are in the route
	group for the numeric pager.

Numeric Pager Capability

The D9412G/D7412G Control Panels can transmit nearly any event to a numeric pager. Any time an event is generated and routed to a numeric pager, the control panel attempts to call the numeric pager once for each message in the queue. To enable the pager, program both the primary and backup phone number to the numeric pager’s phone number in any of the four route groups. Then select which events are to be routed to the numeric pager within the route group selected.

When events are sent to a numeric pager, up to four fields can be displayed in the pager message. See Figure 1.

Figure 1: Pager Display Fields

[1234-001-011-008]

1 2 3 4

1 - Account number (1234)

2 - Event policy (001)

3 - Event number (011, Fire Alarm Event)

4 - User number, point number, or relay number

(008)

The account number must contain four numeric digits. No alpha characters (B to

F)are allowed when using the numeric pager.

Programming the Pager Phone Number

To program the pager phone number, enter the number used to reach the pager, followed by pauses. Entering C creates a 3-second pause (example: 5552341CCC.)

Experiment with the number of pauses you add after the page phone number. Each pause equals 3 seconds. Try calling the pager yourself first and listening to the length of time it takes to get a beep allowing you to enter touch-tone information. This length is what you must program after the pager’s phone number in Section 2.1 Phone. If you need a longer pause, enter D after the number. Each D equals to 7 seconds.

Using “#” characters in the phone number can affect how the event is displayed on the pager:

•No “#” characters in phone number: Dashes appear in the display [1234-001-011-008].

•One “#” character in phone number: Dashes are replaced by zeros [1234000100110008].

•Two or more “#” characters in phone number: Dashes appear in the display [1234- 001-011-008].

For example, if the phone number 2773074#CC (seven-digit pager phone number followed by “#” and two pauses) is programmed, the pager message displays as follows: [1234000100110008] (dashes are replaced by zeros).

If the “#” is not placed in the phone number, the message displays as follows: [1234-001-011-008]

Also, a user may not want all four fields to be displayed in the pager message. “*” characters in the phone number allow the user to select the number of fields to be displayed in the pager message. To limit the number of fields shown in the pager message, enter the appropriate number of “*” characters in the phone number as shown below.

•Zero “*” characters in phone number: All four fields are displayed.

•One “*” character in phone number: First field only is displayed.

•Two “*” characters in phone number: First two fields are displayed.

•Three “*” characters in phone number: First three fields are displayed.

•Four or more “*” characters in phone number: All four fields are displayed.

Bosch Security Systems 1/04 47775E