Bosch Power Tools 2000 4.0Receiver, 4.1Modem Reports, Rcvr Format, Series Program Entry Guide

2000 Series Program Entry Guide 4.0 Receiver

EN 15

4.0Receiver

4.1Modem Reports

1 Rcvr Format

Default:	Modem
Selection:	Modem, Pulse
0		Pulse
1		Modem

Set Rcvr Format to Modem to transmit reports in Modem II format with its advanced reporting capabilities.

You need firmware revision 8.00 or greater installed in your D6500 Receiver.

Table 2 shows the reports available.

The D6500 line card ack tone table must contain “Modem II for D9112.” Refer to the 6500: Line Program Entry Guide.

Set Rcvr Format to Pulse to transmit in 4x2 Pulse Format. Be sure to program codes for each report group. Refer to the Section 4.2 Pulse Report Groups.

Table 2: Modem II Reports Chart

	Modem II Report	Description
	AC FAILURE	No AC power to system. Control panel runs on battery.
	AC RESTORE	AC Power is restored to normal.
	ALARM REPORT POINT	Alarm Report from Points 1 to 24 or from an A, B, C, key. Refer to Section 7.0 ABC Keys for
001 (-099)		instructions on setting reports from the keys.
	ALARM REPORT	If an alarm occurs within 2 minutes of a Closing event, the system sends an Alarm Recent
	RECENT CLOSING	Close Report.
	ID=001
	POINT=001(24)
	ALARM CROSS POINT	Alarm Report from Points 1 to 24 with point code for Cross or Partner point.
	001 (-099)	The ALARM RECENT CLOSE message overrides the ALARM CROSS POINT message.
		The ALARM EXIT ERROR message does not apply to Cross, Partner, Double Knock, or Alarm
		Verification points
	BATTERY LOW	System battery is low.
	BATTERY MISSING	System battery is disconnected. Battery must be missing for 60 seconds.
	BATTERY RESTORE	Missing or low battery is restored.
	CANCEL REPORT	Cancel Report from keyswitch.
	CANCEL REPORT ID	Cancel Report with user ID for users 1 to 8.
001 (-008)

Bosch Security Systems 7/05 35114F