2000 Series Program Entry Guide 18.0 | Keypad Programming |
|
|
EN 65
18.0Keypad Programming
18.1Getting Started
Text Keypad Required: You need a text keypad with its address set to 1 connected to the control panel to use keypad programming. You cannot program from an LED keypad. You do not need to leave the text keypad connected to the system after the programming session.
You do not need to reserve an address for a text keypad to use keypad programming. When the standby switch is locked down, the system allows you to use a text keypad with its address set to 1 for keypad programming, even though address 1 can be programmed for another device.
To start keypad programming:
1.Lock the standby switch down. You must connect a text keypad (address set to 1) to the control panel to program. The text keypad can be removed after programming.
2.Press the [1] key on the text keypad.
3.Enter your installer passcode. The default installer passcode is 654321. The default passcode length is three characters, so if you did not change the default entries, press [6][5][4].
The keypad scrolls the installer menu.
4.Press the [8] key to enter keypad programming, View Mode. If you press the [CLEAR] key now, the keypad exits the Programming Mode and returns to the Installer Menu.
18.2View Mode
In View Mode you can view each program prompt. You must enter the Modify Mode to make changes for any prompt. When you first enter View Mode, you are at Group 1, Prompt 1. Figure 2 shows Group 1, Prompt 1, Account Number, with an entry of 1234.
Figure 2: View Mode
1.1
1234
The group and prompt number appear in line 1. For most prompts, the current entry for the prompt is in line 2. The exceptions are the prompts containing phone numbers, Phone 1, Phone 2, and RAM Phone. The first seven characters for these prompts appear on line 1 with the group and prompt numbers. The remaining characters appear on line 2.
Table 20: View Mode Keys
Pressing the [A] key while in View Mode | |
| enters Modify Mode where you can change |
| the entry for a prompt. Modify Mode is |
| described in the Section 18.3 Modify |
| Mode. |
Pressing the [B] key in View Mode moves | |
| you to the first prompt in the previous |
| group. |
| If you were at 3.2 (group 3, prompt 2), |
| pressing the [B] key moves you to 2.1 |
| (Group 2, Prompt 1). |
Pressing the [C] key in View Mode moves | |
| you to the first prompt in the next group. |
| If you were at 3.2 (Group 3, Prompt 2), |
| pressing the [C] key moves you to 4.1 |
| (Group 4, Prompt 1). |
Pressing the [*] key in View Mode moves | |
| you to the next prompt in the group. |
| If you are at the last prompt in the group |
| when you press the [*] key the system |
| returns to Prompt 1. |
Clear | Pressing the [CLEAR] key in View Mode |
| exits keypad programming. |
|
|
Bosch Security Systems 7/05 35114F
