Bosch Power Tools 2000 2.1Phone Routing Set to No, Phone Routing Set to Yes, DTMF Dialing

2000 Series Program Entry Guide 2.0 Phone

EN 7

2.0 Phone

The Phone Group contains prompts that configure the system for dialing and sending reports on the telephone line.

1 DTMF Dialing

Default:	Yes
Selection:	Yes, No
0	No
1	Yes

When DTMF Dialing is set to Yes, the control panel dials in the Dual Tone Multi-Frequency (DTMF) format for all dialing attempts.

Table 1: Phone Routing Set to No

Attempt	Phone Number
1	Phone Number 1
2	Phone Number 1
3	Phone Number 2
4	Phone Number 2
5	Phone Number 1
6	Phone Number 2
7	Phone Number 1
8	Phone Number 2
9	Phone Number 1

10Phone Number 2

11Communication Fail event

When DTMF Dialing is set to No, the control panel pulse dials for all dialing attempts.

If Phone 2 is left blank, five attempts are made to Phone 1.

2 Phone 1

3 Phone 2

Default: Blank

Selection: 0 to 9, C, D, #, *, Blank

Leaving both Phone 1 and Phone 2 “Blank” creates a local system with no reports transmitted.

Enter up to nineteen characters for each phone number. The # and * characters only work when the control panel is DTMF dialing. The control panel dials these characters just as if you pressed them on a telephone keypad. Enter C for a 3-second delay. Enter D for a 7-second dial tone wait.

If you program a # or * to disable call waiting, warn your customer that eliminating their call waiting service requires a change to their security system.

4 Phone Routing

Default:	No
Selection:	Yes, No
0	No
1	Yes

2.1Phone Routing Set to No

When this prompt is set to the default, No, the control panel dials as shown in Table 1. The control panel only sends reports to Phone 2 after two failed attempts sending to Phone 1.

	If you set the Phone Routing prompt to
	No, skip to Section 4.2 Pulse Report
	Groups. The prompts in the remainder of
	this group set the routing groups.
2.2	Phone Routing Set to Yes

Set this prompt to Yes to route reports to Phone 1 or Phone 2. Reports are routed by group. A description of each routing group follows. The control panel makes five attempts to each routing destination.

Reports routed to Phone 1 have a higher priority than reports routed to Phone 2. When the control panel has reports to send to Phone 1 and Phone 2, it sends all reports for Phone 1, then sends the reports for Phone 2. If the control panel fails to send an event to Phone 1, it creates a Communication Fail event for Phone 1 and begins the Phone 2 Reports.

If the control panel works on Phone 2 Reports and there is a new event for Phone 1, the control panel continues with the Phone 2 Reports until the Phone 2 buffer is empty, and then continues to the Phone 1 event.

Bosch Security Systems 7/05 35114F