Bosch Power Tools 2000 manual 11.4Digit 4, Device Address, Series Program Entry Guide, Point Codes

2000 Series Program Entry Guide 11.0 Point Codes

EN 45

11.4Digit 4, Device Address

Digit 4 is not required for E version control panels. E version control panels only include the On-board points, and they ignore Point Code Digit 4.

Digit 4 tells the system what device a point is connected to. Digit 5 tells the system the sensor loop on the device. The control panel’s On-board points are numbered 1 to 6. Leave Digits 4 and 5 at their default setting (“0” for Digit 4, “A” for Digit 5) for on-board sensor loops. If you program a point number less than 6 to a point expander, the system ignores the control panel’s on-board sensor loop for that point.

For example, to make Point 5 a motion detector connected to loop D of a D222 Text Keypad with Address 7, set the Address 7 prompt in the Address Configuration Group and Digits 4 and 5 of the point code as follows:

•Address 7 = Text Keypad with points

•Digit 4 = 7

•Digit 5 = D (motion detector wired to loop D of the D222 Text Keypad) The control panel ignores the on-board sensor loop for Point 5.

Although eight addresses are available, you can only connect four devices with point expansion to the control panel’s data terminal.

Points with Digit 4 set to an address not programmed for a point expander do not generate Alarm, Trouble, or Missing reports. Refer to Section 10.0 Address Configuration to be certain that any address programmed in Digit 4 of a point code is programmed for a point expander.

Table 8: Digit 4 Selections

	0	1	2	3	4	5	6	7	8
On-Board: Detection devices for this point are connected to one of the control panel’s on-board sensor	X
loops.
Address 1: Detection devices for this point are connected to an expansion device with Address 1.		X
Note:
If you are connecting a text keypad to the system, you must use Address 1.
If you connect more than one text keypad, make sure one of the keypads is set for Address 1.
Address 2: Detection devices for this point are connected to an expansion device with Address 2.			X
Address 3: Detection devices for this point are connected to an expansion device with Address 3.				X
Address 4: Detection devices for this point are connected to an expansion device with Address 4.					X
Address 5: Detection devices for this point are connected to an expansion device with Address 5.						X
Address 6: Detection devices for this point are connected to an expansion device with Address 6.							X
Address 7: Detection devices for this point are connected to an expansion device with Address 7.								X
Note:
If you are connecting a RF Point Expander to the system, it can only use Address 7 or Address 8.
Address 8: Detection devices for this point are connected to an expansion device with Address 8.									X
Note:
If you are connecting a RF Point Expander to the system, it can only use Address 7 or Address 8.

Bosch Security Systems 7/05 35114F