Bosch Power Tools 2000 Remote Programming, RAM Passcode, RAM Phone, Answer Armed, Answer Disarmed

2000 Series Program Entry Guide 5.0 Remote Programming

EN 21

5.0 Remote Programming

Use the prompts in this group to configure your system for programming with a Bosch Security Systems remote programmer.

1 RAM Passcode

Default: 999999

Selection: 0 to 9, A to F

Six characters required. Remote programmers send this code to the control panel to gain access to the control panel.

2 RAM Phone

3 Answer Armed

Default: 0

Selection: 0 to 15

Set the number of rings you want the control panel to wait before seizing the phone line for a remote programming session when the system is All On (armed).

The control panel cannot seize the phone line when the system is All On (armed) if this prompt is set to 0 (zero).

0101	When Answer Machine is programmed
0101
0101	Yes, the entry in Answer Armed has no
	affect on the control panel’s operation.

Default: Blank

Selection: 0 to 9, C, D, #, *, Blank

Enter up to nineteen characters for the control panel to dial to reach a remote programmer. The # and * characters are only dialed when the control panel is programmed for DTMF dialing. Refer to the DTMF Dialing prompt in Section 2.0 Phone. The control panel dials these characters just as if you pressed them on a telephone keypad.

If you program a # or * to disable call waiting, warn your customer that canceling call waiting service requires a change to their security system.

Programming C produces a 3-second dial delay.

Programming D produces a 7-second dial tone wait. If the control panel detects a dial tone before the 7- second delay expires, it continues dialing immediately.

0101	Remote programming initiated from the
0101	keypad ([2] key)
0101
	RAM Phone is blank: After you press [2]
	key, the control panel seizes the phone line
	and waits for the remote programmer
	handshake.
	RAM Phone is programmed with a phone
	number: After you press the [2] key, the
	control panel seizes the phone line, dials the
	RAM Phone number, and waits for the
	remote programmer handshake.

4 Answer Disarmed

Default: 0

Selection: 0 to 15

Set the number of rings you want the control panel to wait before seizing the phone line for a remote programming session when the system is off (disarmed), Part On, or On with No Delay.

If this prompt is set to 0 (zero), the control panel cannot seize the phone line when the system is off (disarmed), Part On, or On with No Delay.

0101	When Answer Machine is programmed
0101
0101	Yes, the entry in Answer Disarmed has no
	affect on the control panel’s operation.

5 Answer Machine

Default: 0

Selection: 0 to 15

Set this prompt to Yes to enable the Answering Machine Bypass feature.

When Answer Machine is programmed Yes, you must set the answering machine to pick up the phone on four or more rings. This feature does not work if the answering machine picks up the phone after one ring.

When Answer Machine is programmed Yes, the control panel picks up the phone for a remote programming session if it detects the following events listed in Table 4.

Bosch Security Systems 7/05 35114F