Bosch Power Tools 2000 manual Point Codes, Series Program Entry Guide

2000 Series Program Entry Guide 11.0 Point Codes

EN 35

11.0 Point Codes

Use the point code charts to set a five-digit point code for each point. The point code determines how the system responds to changes on the point sensor loops. Points respond to opens and shorts.

RF expansion points respond with short for faulted devices.

When an RF point trips, another trip of the same sensor is not detected for 5 or more seconds, depending upon sensor type. Refer to the Installation Manual for a complete description of point sensor loops.

0101

0101

0101

First three digits for E version control panels: E version control panels (for example, D2412UE) only include the On-board points. Point Code Digits 4 and 5 tell the control panel where Off-board points are located. E version control panels ignores Point Code Digits 4 and 5.

The tables on the pages that follow show the defaults and selections for programming.

1 Point 1

Default:	2600A
Selection:	Refer to Table 5, Table 6, Table 7, Table 8, and Table 9 for selections for each digit in the point code.
2600A	Fire point	PT1
	Fire point with alarm verification. Reports and alarm output	FIRE/VERIFY
	enabled.
	Point 1 is powered for two-wire smoke detectors
2 Point 2
Default:	8820A
Selection:	Refer to Table 5, Table 6, Table 7, Table 8, and Table 9 for selections for each digit in the point code.
8820A	Delay Door	PT2
	Delayed Part point. Point arms when user turns the system Part	PART/DELAY
	(or All) On. Point starts entry delay.
	Reports and alarm output enabled.
	Trouble on short when the system is off. Swinger bypass
	enabled.
	Alarm Report delay enabled.
3 Point 3
Default:	8820A
Selection:	Refer to Table 5, Table 6, Table 7, Table 8, and Table 9 for selections for each digit in the point code.
8820A	Delay Door	PT3
	Same response as Point 2.	PART/DELAY

Bosch Security Systems 7/05 35114F