Bosch Power Tools 2000 4.2Pulse Report Groups, Account number 2 - Report group, Point, user, 1213

2000 Series Program Entry Guide 4.0 Receiver

EN 18

4.2Pulse Report Groups

If you select the Pulse Format you need to set the report code for each report group. Pulse 4x2 reports consist of a four-digit account number, a one-digit report group code, and a one-digit point or User ID number.

For example, a control panel with the Account Number prompt set to 1213, the Rcvr Format prompt set to pulse, the Fire Group prompt set to 3, and Point 1 programmed as a Fire point would send the report shown in Figure 1 for an alarm on Point 1.

Figure 1: Pulse Report Groups

1213 3 1

1

2 3

1 - Account number

2 - Report group

3 - Point, user

The Pulse Format allows for only one digit in the Point, User position. If you install more than eight points and report in Pulse Format, the control panel combines reports as shown in Table 3.

Table 3: Pulse Format

Point Number reported in Pulse	1	2	3	4	5	6	7	8
Format
Point Number displayed at keypad	1	2	3	4	5	6	7	8
	9	10	11	12	13	14	15	16
	17	18	19	20	21	22	23	24

Use the following Pulse Report Groups to designate Pulse Report Group codes for this installation.

Do not duplicate Pulse Report Group codes. You cannot distinguish reports from groups with duplicated codes.

The expanded reports available in Modem II format are not available in the Pulse Format.

2 Fire Group

Default:	0
Selection:	0 to 9, B to F
1 to 8	Fire alarm from Points 1 to 24.
9 or 0	Fire alarm from key A, B, or C. Refer to Section 7.0 ABC Keys.
	There is no Pulse Format version of the Modem II Alarm Cross Point Report. The Cross Point
	feature creates two point alarms. Refer to Section 11.0 Point Codes.

Bosch Security Systems 7/05 35114F