Bosch Power Tools 2000 11.1Digit 1, Point Type, Refer to .3 Digit 3, Point Options, Point Codes

2000 Series Program Entry Guide 11.0 Point Codes

EN 37

11.1Digit 1, Point Type

For Digit 1 selections 3, 4, 5, 6, 7, 8, 9, B, C: If an alarm occurs on these points within 2 minutes of a closing (exit time expired, Excursion/Exit included), the system sends a RECENT CLOSING message with the Alarm Report.

For Digit 1 selections 6, 7, 8, 9, B, C: If these points are faulted at the end of exit delay, the system waits a period equal to entry delay before sending an Alarm Report. If the system is not turned off, it sends an EXIT ERROR message with the Alarm Report.

Set Digit 1 to 0 (zero) for points used for RF keypads and arming devices: If you want to use an RF keypad or other arming device, you must assign each device to a point number in order to learn the device into the system. Set Digit 1 to 0 for RF keypad and arming device points.

Table 5: Digit 1 Selections

Display	Selection		Description
0	Disabled	Point does not respond to opens or shorts. Set Digit 1 to 0 if you are using
		this point number for an RF Keypad or arming device.
1	Fire		Short on sensor loop starts fire alarm response.
		Open on sensor loop causes trouble response.
		Fire points are not bypassable. Single Ring programming option does not
		apply to Fire points.
		Missing Fire points generate a trouble response when the system is on or
		off.
2	Fire with Alarm		Short on sensor loop starts verification process:
	Verification (use Fire		1.	Control panel removes power to Point 1 for 4 seconds to reset smoke
	with Alarm Verification			detectors.
	for Point 1 only)		2.	Short on loop within 120 seconds of reset starts alarm response. If the
				point remains normal or open for the 120-second verification window
				no alarm response occurs.
			3.	Verification is not recommended for RF points.
			4.	Missing Fire points generate a trouble response when the system is on
				or off.
			5.	RF Tamper for Fire points generates a trouble response when the
				system is on or off.
			6.	Do not use Fire Alarm Verification points as Cross or Partner points.
				Refer to Section 11.3 Digit 3, Point Options.

Bosch Security Systems 7/05 35114F