Bosch Power Tools 2000 manual Relays, 13.1Relay Function Logic, 13.2Relay Functions, Relay 1 Func

2000 Series Program Entry Guide 13.0 Relays

EN 53

13.0 Relays

A D133 or D134 Relay Module is required to use the system’s external relay outputs (Terminals 9 and 10). One module is required for each output used. Refer to the Installation Manual for instructions.

You can program each of the system’s two relay outputs with one or two functions. With the Relay # Logic prompts, you can configure the outputs so they activate when the condition for either function exists, or only activate when the conditions for both functions exist.

The D5200 Programmer displays an additional relay parameter prompt if the Relay function you selected requires you to program additional information.

For example, if you select the Follow Point function for Relay 1, Func 1 and press [Enter], the D5200 displays the parameter prompts, Point 1 (Yes, No), followed by Point 2 (Yes, No), and so on until Point 24 (Yes, No). The parameter prompts tell the system what points the relay is to follow.

If you select Reset for Relay 1, Func 1 and press [Enter], the D5200 goes directly to Relay 1, Func 2. The Reset function does not require any parameters.

13.1Relay Function Logic

The Relay 1, and Relay 2, Logic prompts allow you to further define the conditions under which the control panel activates the relay drivers.

1 Relay 1 Logic

2 Relay 2 Logic

Default:	Function 1 Only
Selection:	Function 1 Only
	Function 1 or 2
	Function 1 and 2
0	Function 1 Only
1	Function 1 or 2
2	Function 1 and 2

When Relay 1 Logic or Relay 2 Logic is set to Function 1 Only, the system activates the relay output when Function 1 calls for activation. Function 2 is ignored.

When Relay 1 Logic or Relay 2 Logic is set to Function 1 or 2, the system activates the relay output when either Function 1 or Function 2 calls for activation, or when both do.

When Relay 1 Logic or Relay 2 Logic is set to Function 1 and 2, both Function 1 and Function 2 must call for activation before the system activates the relay output.

13.2Relay Functions

3 Relay 1 Func 1

Default: No Output

Selection: Refer to Table 18 (0 to 24)

The Relay 1, Func 1 prompt sets Function 1 for Relay Output 1 (Terminal 9).

4 Relay 1 Func 2

Default: No Output

Selection: Refer to Table 18 (0 to 24)

The Relay 1, Func 2 prompt sets Function 2 for Relay Output 1 (Terminal 9).

5 Relay 2 Func 1

Default: No Output

Selection: Refer to Table 18 (0 to 24)

The Relay 2, Func 1 prompt sets Function 1 for Relay Output 2 (Terminal 10).

6 Relay 2 Func 2

Default: No Output

Selection: Refer to Table 18 (0 to 24)

The Relay 2, Func 6 prompt sets Function 6 for Relay Output 2 (Terminal 10)

Bosch Security Systems 7/05 35114F