
10. STANDARD ADJUSTMENTS
0.01− 0.08mm (Seatbelt: 0.1 – 0.2 mm)
0138Q | 3126B |
Turn the pulley in the direction of the arrow to align the tip of the rotary hook with the center of the needle, and then loosen the set screw (1) and turn the eccentric shaft (2) to adjust so that the clearance between the needle and the rotary hook is 0.01 to 0.08 mm.
3574Q
Install the shuttle race thread guide (1) by pushing it in the direction of the arrow so that the needle groove is aligned with the center of the needle plate hole.
NOTE:
If the shuttle race thread guide is in the wrong position, thread breakages, soiled thread or tangling of the thread may occur.
The position of the shuttle race thread guide is adjusted at the time of shipment from the factory. It should not be changed if possible.
More oil | Less oil |
|
The optimum position is when the head of the set screw (1) is aligned with the edge of the bed. The rotary hook lubrication amount can be adjusted within three turns to the right from that position.
•If the set screw (1) is turned clockwise, the lubrication amount becomes smaller.
•If the set screw (1) is turned counterclockwise, the lubrication amount becomes greater.
Aligned
3127B
60 |