
5. USING THE OPERATION PANEL (BASIC OPERATIONS)
3 | Press the key. |
| The sewing machine will switch to intermittent presser foot height |
| setting mode. |
| • " 4" will appear in the PROGRAM No. display, and the work clamp |
| will rise to the setting value that appears in the menu display. |
| (Intermittent presser foot height setting: 0.0 − 10.0) |
<Changing modes>
Press the or
key to set the intermittent presser foot height.
•The intermittent presser foot will rise or drop to the height of the new value that has been set.
•If you press the RESET key while the height display is flashing, the setting value will return to the value before the change was made.
•Press the ENTER key to accept the setting.
NOTE:
After making the setting, be sure to turn the pulley once by hand and check that the intermittent presser foot does not touch the needle bar.
3092B
" 1" Threading mode
↑↓
"2" Work clamp height setting mode
↑↓
"3" Intermediate work clamp height setting mode (*)
↑↓
"4" Intermittent presser foot height setting mode
*When the setting value for memory switch No. 003 is “2” Pneumatic work clamp specifications
"1" Threading mode
↑↓
"4" Intermittent presser foot height setting mode
3093B
4 | Ending setting mode | Press the THREAD/CLAMP key. | |
|
| • | The setting values will be memorized. |
|
| • | The work clamp will return to where it was before setting mode |
|
|
| was started. |
| THREAD/CLAMP indicator switches off |
|
|
|
|
| |
Intermittent presser foot operation |
| 1 Intermittent presser foot lift amount | |
| During standby |
| |
|
| 2 Intermittent presser foot height | |
|
|
| The settings can be made by the above |
|
|
| operations. |
|
|
| However, set the intermittent presser foot |
|
|
| height to a higher setting than the intermittent |
|
|
| stroke. |
| When lowered |
| * If it is set smaller, the intermittent presser |
|
| foot will come into contact with the needle |
| plate. |
| 3 Intermittent stroke |
| Refer to |
While sewing | work clamp” when making the adjustment. |
| |
5033Q |
|
39 |