10. STANDARD ADJUSTMENTS

10-9. Adjusting the position of the movable knife

3059B

 

 

3355B

3350B

 

 

 

 

 

 

 

 

 

 

 

 

 

 

<View from side of thread trimmer cam>

Reverse position (position where driving lever is at its lowest point)

3351B

3352B

1.Open the top cover and tilt back the machine head.

2.Turn the pulley (1) by hand to move the needle bar to its lowest position.

3.Loosen the nut (2), tighten the set screw (5) until the collar (3) touches the inside of the groove in the thread trimmer cam (4), and then loosen the set screw (5) by approximately 1/4 of a turn.

4.Tighten the nut (2), and then check that the collar (3) is not touching the inside of the groove in the thread trimmer cam (4). In addition, push the driving lever (6) by hand toward the thread trimmer cam until the collar (3) touches the groove of the thread trimmer cam (4), and then check that the driving lever (6) returns smoothly to its original position when it is released.

5.Turn the pulley (1) by hand in the direction of the arrow to move the needle bar to its lowest position, and push the thread trimming solenoid (7) as far as it will go.

6.With the collar (3) inserted into the groove of the thread trimmer cam (4), turn the pulley (1) by hand to set the driving lever

(6)to the reverse position and so that the driving lever (6) is at its lowest point (when the thread take-up (8) is close to its lowest position).

61

BAS-311H