Brother BAS-311H 6-2.List of memory switch settings, 6. USING THE OPERATION PANEL (ADVANCED OPERATIONS)

6. USING THE OPERATION PANEL (ADVANCED OPERATIONS)

6-2. List of memory switch settings

No.	Setting	Setting items	Initial value
	range
	Work clamp lift timing after sewing is completed
001	0	Work clamp is not raised automatically.	2
	1	Work clamp is raised at the final stitch position.
	2	Work clamp is raised after moving to the home position.
	Work clamp	lowering sequence for separate work clamp (pneumatic work clamp specifications
002	only)		0
	0	Left and right work clamps are lowered at the same time.
	1	Work clamp is lowered in the order left -> right.
	2	Work clamp is lowered in the order right -> left.
	Work clamp	lowering operation (Motor-driven work clamp specifications only)
		Analog lowering: Work clamp is lowered in direct proportion to the pedal
	0	depression amount, and sewing starts when the pedal is fully depressed.
		＊This operation is only possible for foot switch specifications; for two-pedal foot
003		switch specifications, operation is the same as for a 2-step work clamp.	2
	1	1-step work clamp: Work clamp is lowered when pedal is depressed to the 1st
		step, and sewing starts when pedal is depressed to the 2nd step.
		2-step work clamp: Work clamp is lowered to intermediate height when pedal is
	2	depressed to the 1st step, and work clamp is fully lowered and sewing starts when
		the pedal is depressed to the 2nd step.
	Slow start method
		The sewing speed for the first 5 stitches will be in accordance with the setting for	OFF
100	OFF	memory switch Nos. 151 to 155. (Ask the place of purchase for details on memory
		switch Nos. 151 to 155.)
	ON	The sewing speed for the first 5 stitches can be selected from the nine slow start	Lo4
		patterns “Lo1” to “Lo9”. (Refer to “5-2-1. Parameter list”.)
	Single-stitch	test feed
	OFF	Test feed starts when the foot switch (start switch) is depressed, and it continues
		automatically until the final stitch.
200			OFF
		Test feed starts when the foot switch (start switch) is depressed, and it moves
	ON	forward by one stitch each time the switch is depressed. In addition, when the
		TEST indicator is flashing, test feed will move forward one stitch at a time when
		the machine pulley is turned by hand.
300	Production counter display		OFF
	OFF	Lower thread counter display
	ON	Production counter display
400	Sewing condition detail settings		OFF
	OFF	Parameters which are common to all programs are used.
	ON	Parameters can be set separately for each program.
402	Unit display for pattern zoom ratio		OFF
	OFF	Displayed as %.
	ON	Displayed as mm.
403	Split mode selection		0
	0	Continuous split mode
	1	Single split mode
405	Cycle program	No. (C01 to C30) display	ON
	OFF	Disabled (not displayed)
	ON	Enabled (displayed)

41 BAS-311H