INSTALLATION

2.Press the MicroMMAC-T’s Reset button.

Once the module is reset, use the factory-default settings or enter new parameters. The MicroMMAC-T stores these settings in NVRAM during normal operation and during power down until the reset switch is toggled again.

NOTE: Clearing and resetting NVAM does not reset the date and time.

3.8 CONNECTING LOBE PORT CABLING

The MicroMMACs 22T and 24T have unshielded RJ45 lobe ports that support UTP cabling. To connect a UTP segment from the MicroMMAC-T to a station supporting STP cabling, a Type 3 Media Filter is required. The Cabletron Systems TRMF and TRMF-2 are available for this purpose.

The MicroMMACs 42T and 44T have shielded RJ45 lobe ports that support STP cabling. Shielded patch cables that adapt a shielded RJ45 to a data connector (MIC) are available from Cabletron Systems (PN 9372057-8). These adapter/patch cables allow connection to an existing patch panel equipped with data connectors. The MicroMMAC-T’s network lobe port pinouts are shown in Figure 3-9.

RJ45 Plug

Black

8 1

Orange

Green

Blue

MIC Connector

RJ45 Plug

to

MIC Connector

Pin 3

(Receive -) .

. . . . . . . . to . . .

Green (Transmit -)

Pin 4

(Transmit +) .

. . . . . . . . to . . .

Orange (Receive +)

Pin 5

(Transmit -) .

. . . . . . . . to . . .

Black (Receive -)

Pin 6

(Receive +) .

. . . . . . . . to . . .

Blue (Transmit +)

3-8

Page 43
Image 43
Cabletron Systems MICROMMAC-22T, 42T manual Connecting Lobe Port Cabling, RJ45 Plug MIC Connector