Cisco Systems AS5400XM manual Configuring Input Impedance for the E1 Feature Card, Configuration

Chapter 3 T1 and E1 Feature Cards

Configuring Input Impedance for the E1 Feature Card

Note For information about configuring the T1 or E1 ports, see the Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide.

Configuring Input Impedance for the E1 Feature Card

You can set the input impedance of the E1 feature card before or after running the setup script. For information on configuring the universal gateway with the setup script, see the Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide.

Configuration

	To set the input impedance for the E1 feature card, use the line-terminationcommand.
	Command	Purpose
Step 1
	Router> enable	Enters enable mode.
	Password: password	Enter the password. You have entered enable mode when
	Router#
		the prompt changes to Router#.
Step 2
	Router# configure terminal	Enters global configuration mode. You have entered
	Enter configuration commands, one per line. End	global configuration mode when the prompt changes to
	with CNTL/Z.	Router(config)#.
	Router(config)#
Step 3
	Router(config)# controller e1 0	Enter the controller number on which you are configuring
	Router(config-controller)#	input impedance.
Step 4
	Router(config-controller)# line-termination	Sets the input impedance to 75 ohm for the controller.
	75-ohm	The factory-set default is 120 ohm. Repeat Step 3 and
		Step 4 for the other controllers.
Step 5
	Router(config-controller)# Ctrl-Z	Returns to enable mode.
	Router#	This message is normal and does not indicate an error.
	%SYS-5-CONFIG_I: Configured from console by
	console

Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide

78-17406-01 3-11