Chapter 5 Universal Port and
Online Insertion and Removal of the Universal Port or
Online Insertion and Removal of the Universal Port or
To remove a feature card without dropping any calls or connections, you will need to take the feature card out of service by using the busyout command to disable the feature card. The busyout command is executed on a
If there are active calls on the feature card after you execute the busyout command, wait for the calls to drop. To view the status of the termination process, use the show busyout command.
Caution The online installation and removal (OIR) of new cards should be done only during times of low CPU utilization, such as during maintenance.
Caution To avoid erroneous failure messages, remove or insert only one feature card at a time.
When you replace a feature card in a slot with a new feature card of the same type, the system software recognizes the new feature card and brings up the trunk interfaces automatically.
If you replace the existing feature card with a new feature card of a different type, you must reconfigure the system. For configuration details, see the Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide. For information on voice and fax commands, see the Monitoring Voice and Fax Services on the Cisco AS5350 and Cisco AS5400 Universal Gateways online document.
Removing the Universal Port or Dial-Only Feature Card
To remove the universal port or
Note An example showing the output from each command is provided after the procedure. See the “Online Insertion and Removal Example for the Universal Port or
Step 1 Determine which slot the feature card is in (see Figure
Router# show chassis slot
Note These commands are not valid for slot 0. Slot 0 is the motherboard.
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
|
|
| |
|
|
