![](/images/new-backgrounds/1142306/14230693x1.webp)
Chapter 4 Channelized T3 Feature Card
Online Insertion and Removal of the CT3 Feature Card
Figure 4-3 Slot Numbering on the Cisco AS5400XM Chassis
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Slot 0 | Slot 1 |
|
| ||
| Slot | 2 |
| Slot | 3 |
| |
Slot | 4 |
|
| Slot | 5 |
34977
Slot 6Slot 7
Step 2 Initialize the software busyout procedure by entering the busyout command:
Router# busyout
Step 3 Check busyout status for the slot, by entering the show busyout command.
Router# show busyout
Step 4 You can use the clear port command to immediately disable active calls on the universal port,
Router# show controller t3
Router# clear port
Note The clear port command applies only to universal port,
Step 5 Verify that the OK/MAINT LED is off; this indicates that the feature card is offline and ready to be removed.
Note The OK/MAINT LED is green before you enter the busyout command. After you enter the busyout command, the LED changes to yellow. The LED turns off after all calls are disconnected and resources are taken out of service, indicating that busyout is complete.
Step 6 Attach an
Warning Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Step 7 Disconnect all interface cables from the feature card and secure them out of the way.
Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
|
|
| |
|
|