Cisco Systems AS5350XM, AS5400XM manual Show busyout

Chapter 5 Universal Port and Dial-Only Feature Cards

Online Insertion and Removal of the Universal Port or Dial-Only Feature Card

Figure 5-7 Removing the Feature Card from the Cisco AS5400XM Universal Gateway

37172

Caution Avoid touching any pins or circuit board components when you remove or install a feature card.

Step 9 After you remove the feature card, set it aside on an ESD-preventive mat.

Step 10 If the feature card slot is to remain empty, install a blank cover over the open feature card slot to ensure proper airflow inside the chassis. (See Figure 5-8.)

Figure 5-8 Blank Feature Card Cover

36033

Online Insertion and Removal Example for the Universal Port or Dial-Only Feature Card

The following output is an example of the online insertion and removal (OIR) process for a universal port feature card in slot 3 of the universal gateway:

Router# show chassis slot 3

Slot 3:

DFC type is NP108 DFC

OIR events:

	Number of insertions = 0, Number of removals = 0
DFC State is DFC_S_OPERATIONAL
Router#
Router#	show busyout 3
Slot 3	is not being busied out
Router#
Router#	busyout 3
Busyout	in progress for 3
Router#
Router#	show busyout 3

Slot busyout is in progress

Slot 3:Pending (64 calls remaining)

		Router#
		Router# show chassis slot 3
		Slot 3:
		DFC type is NP108 DFC
		Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide
5-6	78-17406-01