Cisco Systems AS5350XM, AS5400XM manual Installing the Universal Port or Dial-Only Feature Card

Chapter 5 Universal Port and Dial-Only Feature Cards

Online Insertion and Removal of the Universal Port or Dial-Only Feature Card

Router# show chassis slot 3

Slot 3:

DFC type is NP108 DFC

OIR events:

Number of insertions = 1, Number of removals = 1

DFC State is DFC_S_OPERATIONAL

Installing the Universal Port or Dial-Only Feature Card

Warning Do not work on the system or connect or disconnect cables during periods of lightning activity.

Statement 1001

Note When you replace a feature card with a new feature card of the same type in the same slot, the system software recognizes the new feature card and brings up the trunk interfaces automatically. If you replace the existing feature card with a new feature card of a different type, you must reconfigure the system.

For configuration details, see the Cisco AS5350XM and Cisco AS5400XM Universal Gateways Software Configuration Guide.

To install the universal port or dial-only feature card, follow these steps:

Step 1 Attach an ESD-preventive wrist strap.

Step 2 Slide the feature card into the slot until the connector pins make contact with the carrier card backplane connector. (See Figure 5-9and Figure 5-10.)

Figure 5-9 Installing the Universal Port or Dial-Only Feature Card in the Cisco AS5350XM Universal Gateway

36820

Cisco AS5350XM and Cisco AS5400XM Universal Gateways Card Installation Guide

5-8 78-17406-01