Cisco Systems 2900, OL-24281-01 manual Switch Settings, Special Systems, Serial Port Settings, 1-11

Chapter 1 Installation

Switch Settings

Step 3 Tighten the captive Phillips pan head screws to secure the lower dome (see Figure 1-12).

Figure 1-12 Installing the Pendant Lower Dome

Switch Settings

Table 1-3shows SW2 switch settings.

Note If you are using Pelco D-type or Pelco P-type control, your system may not operate if the baud rate and

address switches are not set correctly. The switches are set at the factory using the defaults for Pelco D-type control (2400 baud and address 1).

	Table 1-3	Switch Settings for SW2
	Special Systems
	Switch Number			1	2	3	4	5	6	7	8	9		10
	AD-32 Preset System			ON
	CM9502 Setting				ON
	Serial Port Settings
	Switch Number			1	2	3	4	5	6	7	8	9		10
	RS422						OFF	OFF
	RS485, 4-Wire						OFF	ON
	RS485, 2-Wire						ON	ON
			Cisco Video Surveillance IP PTZ Dome Camera User Guide, Cisco 2900 Series IP Dome
OL-24281-01													1-11