Cisco Systems OL-27407-01 manual Mounting the Cisco 812 ISR on a Hard Ceiling or a Wall

Chapter 2 Installing the Router

Installing the Cisco 810 ISR

Figure 2-14 Suspended Ceiling Mounting Details

1 7 8 2

4 5 3 6

344533

1	To PoE+ power source	5	GE CAT5 cable to PoE+ splitter
2	Ceiling T-rail	6	Power and GE cable routed through a ceiling
			mounting bracket and into the router so that the
			cabling is hidden from directly below
3	Ceiling tile with opening cut for	7	Ceiling grip clip
	cables
4	Power cable to PoE+ splitter	8	Ceiling mount bracket

Mounting the Cisco 812 ISR on a Hard Ceiling or a Wall

This procedure describes the steps required to mount the Cisco 812 ISR on a ceiling constructed of 3/4-inch (19.05 mm) or thicker plywood using #8 fasteners using the universal mounting bracket (C810-BR-CM).

Note The Cisco 812 ISR integrated antennas perform best when the router is mounted on horizontal surfaces such as a table top or ceiling. For advanced features such as voice, location, and router detection, ceiling mounting is strongly recommended. However, for smaller areas such as conference rooms, kiosks, transportation environments, or hot-spot usage where data coverage is the primary concern, the unit may be wall mounted using wall anchors or screws.

	Cisco Integrated Services Router Hardware Installation Guide
OL-27407-01		2-15