Chapter 4 Initial Configuration

Cisco 860, 880, 890 Series

Please change these publicly known initial credentials using Cisco CP Express or the Cisco

IOS CLI.

Here are the Cisco IOS commands.

username <myuser> privilege 15 secret 0 <mypassword> no username username1

Replace <myuser> and <mypassword> with the username and password you want to use.

For more information about Cisco CP please follow the instructions in the QUICK START

GUIDE for your router...

...

User Access Verification

Username:

Step 3 Enter the username username1, and press Return or Enter. The following prompt is displayed:

Password:

Step 4 Enter the password password1, and press Return or Enter. The following prompt is displayed:

Router#

A message is displayed that is similar to the first warning message. The message directs you to change the username and password.

You are now in privileged EXEC mode.

Note You must change the username and password before you log off the router. You cannot use the username username1 or password password1 after you log off from this session.

Step 5 Enter configuration mode using the following commands.

Router#

Router#config t

Router(config)#

Router(config)#username username privilege 15 secret 0 password

Step 6 To change the username and password, enter the following at the prompt:

username username privilege 15 secret 0 password

The username and password are the username and password that you determine.

To continue using the Cisco IOS CLI for initial configuration, see the applicable configuration procedures in Cisco 860 Series, Cisco 880 Series, and Cisco 890 Series Integrated Services Routers Software Configuration Guide.

Note Save your configuration changes regularly to avoid losing them during resets, power cycles, or power outages. Use the copy running-configstartup-configcommand at the privileged EXEC mode prompt (Router#) to save the configuration to NVRAM.

Step 7 Verify the initial configuration. See the “Verifying the Initial Configuration” section on page 4-2.

Cisco Integrated Services Router Hardware Installation Guide

 

OL-23125-02

4-3

 

 

 

Page 221
Image 221
Cisco Systems OL-27407-01 manual Username username privilege 15 secret 0 password