Cisco Systems OL-27407-01 manual Verifying the Initial Configuration, Configuration is displayed

Chapter 4 Initial Configuration

Cisco 860, 880, 890 Series

The configuration is displayed:

The following configuration command script was created:

hostname Router

enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1 enable password xxxxxx

line vty 0 4 password xxxxxx

snmp-server community public

!

no ip routing

!

interface FastEthernet4 no shutdown

speed 100 duplex auto

ip address 172.1.2.3 255.255.0.0

!

Step 12 Respond to the following prompts. Enter 2 to save the initial configuration.

[0]Go to the IOS command prompt without saving this config.

[1]Return back to the setup without saving this config.

[2]Save this configuration to nvram and exit.

Enter your selection [2]: 2

Building configuration...

Use the enabled mode 'configure' command to modify this configuration.

Press RETURN to get started! RETURN

The user prompt is displayed.

Router>

Step 13 Verify the initial configuration. See the “Verifying the Initial Configuration” section on page 4-2for verification procedures.

After the initial configuration file is created, you can use the Cisco IOS CLI to perform additional configuration.

Verifying the Initial Configuration

To verify that the new interfaces are operating correctly, perform the following tests:

•To verify that the interfaces and line protocol are in the correct state—up or down—enter the show interfaces command.

•To display a summary status of the interfaces configured for IP, enter the show ip interface brief command.

•To verify that you configured the correct hostname and password, enter the show configuration command.

After you complete and verify the initial configuration, you can configure your Cisco router for specific functions.

Cisco Integrated Services Router Hardware Installation Guide

4-6 OL-23125-02