Cisco Systems OL-27407-01 manual Installing the Router

Chapter 2 Installing the Router

Installing the Cisco 810 ISR

If you plan to configure the software using Cisco IOS commands through the console port, provide an ASCII terminal or a PC that is running terminal emulation software to connect to the console port.

If you plan to connect a modem, provide the modem and modem cable.

Installing the Router

This section describes how to install the Cisco 819 ISR. These routers can be installed on a table top or other flat horizontal surface mounted on a wall or DIN rail.

The recommended clearance when horizontally mounted is 1.5 inches on both sides for floor mount bracket clearance and 2 inches on top. Top clearance is not required but stacking heat-dissipating objects on top of the router is not allowed. I/O side clearance is needed as it is required to access the cable connections. Clearance is not required on the backside (opposite side from I/O face) unless DIN rail mounting is required. Clearance is required to attach and mount the DIN rail bracket. The same clearances apply when mounted vertically.

This section also describes how to attach external antennas to the routers and contains the following topics:

•Warnings, page 2-22

•Accessing the SIM Card, page 2-23

•Installing Antennas, page 2-24

•Installing a WiFi External Antenna, page 2-24

•Installing on a Table, page 2-25

•Mounting on a Wall, page 2-25

•Installing a DIN Rail, page 2-27

•Installing the Router Using the Configurable Low Profile DIN Mount, page 2-30

•Installing the Power Cord Retention Lock, page 2-34

•Installing the Power Switch Lock, page 2-35

Warnings

Warning This equipment needs to be grounded. Use a green and yellow 12 to 14 AWG ground wire to connect the host to earth ground during normal use. Statement 242

Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024

Warning Read the wall-mounting instructions carefully before beginning installation. Failure to use the correct hardware or to follow the correct procedures could result in a hazardous situation to people and damage to the system. Statement 378

	Cisco Integrated Services Router Hardware Installation Guide
2-22	OL-27407-01