Cisco Systems OL-27407-01 manual Connecting an FXS Line

Chapter 3 Connecting the Router

Cisco 860, 880, 890 Series

Step 3 Snap the latches into the holes on either side of the power connector. See Figure 3-35.

Figure 3-35 Power Lock Clip Latched Into the Holes on Either Side of the Power Connector

1

2

4

3

270800

1

2

Power lock clip	3	Power adapter
Power cord	4	AC plug

Connecting an FXS Line

Use a standard straight-through RJ-11 modular telephone cable to connect a Foreign Exchange Service (FXS) port to a telephone or fax machine.

Warning This equipment contains a ring signal generator (ringer), which is a source of hazardous voltage. Do not touch the RJ-11 (phone) port wires (conductors), the conductors of a cable connected to the RJ-11 port, or the associated circuit-board when the ringer is active. The ringer is activated by an incoming call. Statement 1042

Warning Hazardous network voltages are present in WAN ports regardless of whether power to the unit is OFF or ON. To avoid electric shock, use caution when working near WAN ports. When detaching cables, detach the end away from the unit first. Statement 1026

Warning For connections outside the building where the equipment is installed, the following ports must be connected through an approved network termination unit with integral circuit protection: FXS. Statement 1044

	Cisco Integrated Services Router Hardware Installation Guide
OL-23125-02		3-39