Cisco Systems OL-27407-01 manual Installing a DIN Rail, Installing the Router to the Wall

Chapter 2 Installing the Router

Installing the Cisco 810 ISR

Figure 2-22 Installing the Router to the Wall

282623

Note For hollow-wall mounting, each bracket requires two wall anchors with washers. Wall anchors and washers must be size number 10.

Step 4 Route the cables so that they do not put a strain on the connectors or mounting hardware.

To comply with IP 41, cables should be routed down relative to the router to prevent water from travelling on the cables.

Installing a DIN Rail

You can use either the 7.5-mm or the 15-mm thick DIN rail for the Cisco 819 ISR. Secure the DIN rail to the mounting surface approximately every 7.8 inches (200 mm) and use end-anchors appropriately.

Note DIN rail mounting is not supported on Cisco 819HGW and Cisco 819HWD ISRs.

	Cisco Integrated Services Router Hardware Installation Guide
OL-27407-01		2-27