Chapter 1 Product Overview

Cisco C891 Series ISRs

2.LWAPP = Lightweight Access Point Protocol.

3.PPP = Point-to-Point Protocol.

4.xDSL = General term referring to various forms of DSL, including ADSL (asymmetric digital subscriber line) and VDSL (very-high-data-rate digital subscriber line).

5.DSLAM = digital subscriber line access multiplexer.

6.ATM = Asynchronous Transfer Mode.

7.EFM = Ethernet in the First Mile.

8.3G = Third-Generation.

9.WWAN = wireless WAN.

10.RSSI = Received Signal Strength Indicator.

11.GSM = Global System for Mobile Communication.

12.CDMA = code division multiple access.

13.SRST = Survivable Remote Site Telephony.

14.SFP = small-form-factor pluggable.

Table 1-30describes the LEDs for the Cisco 866VAE, Cisco 867VAE, Cisco 866VAE-K9, and Cisco 867VAE-K9 ISRs.

Table 1-30

LED Descriptions for the Cisco 866VAE, Cisco 867VAE, Cisco 866VAE-K9, and Cisco 867VAE-K9 ISRs

 

 

 

 

LED

 

Activity

Description

 

 

 

 

Power/System

 

Power/System LED: Solid

Power is on and system running in the Rommon mode.

 

 

GE_MODE LED: Off

Note During the early booting stage, both Power/System, GE_MODE and

 

 

DSL_LINK LED: Off

 

 

DSL_LINK LED will be turned on temporarily for the power on test.

 

 

 

 

 

 

DSL_LINK and GE_MODE LED will be turned off later after booting

 

 

 

into Rommon.

 

 

 

 

 

 

Power/System LED: Solid

IOS functioning in GE WAN mode.

 

 

GE_MODE LED: Solid

 

 

 

DSL_LINK LED: Off

 

 

 

 

 

 

 

Power/System LED: Solid

IOS functioning in DSL_WAN mode.

 

 

GE_MODE LED: Off

Note In IOS DSL_WAN mode, DSL_LINK LED will be solid after DSL

 

 

DSL_LINK LED: Solid or

 

 

training complete or flashing during training.

 

 

flashing

 

 

 

 

 

 

 

xDSL1 ACT

 

Green

On—DSL interface is up.

 

 

 

Blinking—DSL WAN activity (traffic in either direction).

 

 

 

Faster blinking—Heavier traffic

 

 

 

Off—Device is powered off or the DSL WAN interface is down.

 

 

 

 

xDSL Link

 

Green

On—DSL WAN Mode is selected and DSL training complete.

 

 

 

Blinking—DSL WAN Mode is selected but incomplete DSL Link Up state,

 

 

 

such as in-training, or controller “OFF,” or no cable attached to DSL connector.

 

 

 

Off—Device is powered off or GE WAN mode is selected.

 

 

 

 

 

 

Cisco Integrated Services Router Hardware Installation Guide

 

 

 

 

 

 

OL-27407-01

 

 

1-83

 

 

 

 

 

Page 103
Image 103
Cisco Systems OL-27407-01 manual Activity Description